Electrical power UNITS FOR LIFT TABLE

Energy UNITS FOR LIFT TABLE 1
General Description
This energy unit is developed solely for your smaller lift table,Consisting of large pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit has been extensively utilized while in the industry of logistic gadgets such as minifork lift, scissors lift and ariel working platforms. The lower-ing movement is controlled by the solenoid valve with all the speed controlled from the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
General Description
This energy unit is created solely to the medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve and also the pace managed through the adjustable needle valve. Once the lift rises to a higher positoin, but the power supply is reduce, the lowering movement is controlled from the manual override function.
Energy UNITS FOR LIFT TABLE 3
Common Description
This power unit is made exclusively for that substantial lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve and also the pace managed by a pressure compensated flow control valve.
Power UNITS FOR LIFT TABLE four
Basic Description
This electrical power unit is made solely to the significant lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve and the pace controlled through the adjustable needle valve. Once the lift rises to a substantial positoin, but the electrical power provide is cut, the reducing movement is managed through the manual override function.
Special Notes
one. This electrical power unit is of S3 duty cycle, which might only get the job done intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean all the hydraulic elements concerned just before set up of the energy unit.
three. Viscosity in the oil shoud be 15~46 cst,which ought to also be clean and free of charge of impurities.N46 hydraulic oil is proposed.
4. Oil changing is required soon after the first one hundred operation hrs,afterwards when every 3000 hrs.
five. The energy unit proven is intended to be mounted vertically.